1, a stepping motor is applied to low-speed situations --- the rpm of no more than 1000 rpm, (0.9 degrees 6666PPS), is preferably used (0.9 °) 1000-3000PPS, allows it to operate here through the reduction means, At this time, a high motor efficiency, low noise; 
2, a stepping motor is preferably used not state the whole step, a large vibration state of the whole step; 
3, due to historical reasons, the use of only a nominal voltage of 12V outer motor 12V, another motor voltage value is not the driving voltage value V, the driving voltage can be selected according to driver (recommended: 57BYG DC 24V-36V, 86BYG DC 50V, 110BYG using higher than the DC 80V), of course, in addition to 12 volts 12V constant voltage drive also outside other drive power can be employed, but to consider the temperature rise; 
4, the moment of inertia of the load should be chosen larger frame size motor; 
5, at a relatively high speed motor or high inertia loads, generally do not start operating speed, while the use of gradually upscaling speed, without losing a step motor, two noise can be reduced while improving the accuracy of the positioning stop; 
6, high-precision, by mechanical reduction should improve the speed of the motor, or driven high number of segments using Is solved, 5-phase motor may be used, but the price of the entire system is more expensive, less manufacturer, that is to say is eliminated layman; 
7, the vibration motor not working area, should be available by changing the voltage , current or add some damping solutions; 
8, (0.9 degrees) in the following work 600pps motor, should be a small current, high inductance, low voltage drive; 
9, after the first selected should follow the principle of the motor drive is selected.